Mistakes can occur during installation (interlocking paver plant for sale). These include inadequate compaction of the soil below the interlocking pavers, an excessively thick sand layer, failure to set the starting strings square and at a right angle, and assigning piecework or contracts to installers without carefully inspecting and accepting their work.
Allowing vehicles or equipment onto the pavers before the edge pieces and joint sand are complete is another mistake (interlocking paver plant for sale). These and other causes can produce problems that are not discovered until after installation.
The main problems include irregular paver lines that look crooked, spoil the appearance and leave uneven closing pieces; lipping between pavers that harms both appearance and function; and an uneven surface that creates bumps felt by pedestrians and vehicles.
I have personally experienced this, as the following photos show, and took these steps to solve the problem. I identified the nearest acceptable straight line in both directions and used them as a new starting point (interlocking paver plant for sale). I removed the pavers beyond those lines and compacted the ground again in the area needing correction.
The poorly aligned areas are relaid, with care to keep the lines straight in both directions (interlocking paver plant for sale). Once installation is complete, screened sand is brushed into the joints, and the entire area is covered with fine screened sand.
A compactor is passed over the whole paved area without operating it at high speed, to level the surface and remove lipping (interlocking paver plant for sale).
The lesson is not to rely unquestioningly on an installer, however skilled. Please share your opinion, leave a comment, and share the article with friends if you enjoyed it. Best regards — interlocking paver plant for sale.